|
Post by robdawg on Dec 15, 2010 22:05:01 GMT -5
Working on some U36B kit bashes and some U36C's and noticed that Atlas only made the radiator section for the U36C's with the drip edge on the lower section of the radiator. Any ideas on when this was changed on the prototype from being in the upper position? Or vice versa? What would one do to correct this for a drip edge in the raised position. I hate to try and take the drip edge off and replace it with a new one, or model the U36B's without it. I could do it, just looking for other ideas. Thanks Peacedawg
|
|
|
Post by robdawg on Oct 9, 2011 20:09:50 GMT -5
Did some more research finally and I think I have found my answer. The Atlas part is wrong for what I want to do with these models but it will have to work, as I have no interest in shaving off the access panels on the radiator section and moving them up to the proper location. Rob
|
|