|
Post by riss2509 on Aug 12, 2010 9:29:03 GMT -5
Is it possible to program a strobe light to flash through the athearn board and quick plug with a 4 function decoder? Im using a NCE D13SRJ and was going to use decoder pro tonight at the club. Thanks!
|
|
|
Post by markdeimling on Aug 20, 2010 11:06:43 GMT -5
What model is this in?
I got mine to work on a Athearn MP15AC using the stock lighting board with a Digitrax 163 decoder. I plugged the decoder into the 9 pin plug on the board. Athearn soldered the strobe light to the rear light terminal but I just moved it to the F1 terminal on the athearn board. Then program the CV, which I think is 51 or 52. Then set the FX function, mine is I think was single strobe in forward and reverse. Hope this makes sense or even answers the original question.
|
|
|
Post by sd45longhoodfoward on Aug 20, 2010 13:31:47 GMT -5
check you decoder manual see what its functions are. then if it support strobe function install it and program the proper cv;s most 4 function decoder's cover most lighting functions
|
|