|
|
Post by montyvox on Dec 4, 2009 10:57:01 GMT -5
Good morning everyone-
I am looking to put a sound decoder in a RTR Athearn SD40-2, and I would like to put a railmaster speaker in it.
Does anyone have any suggestions on the right speaker for it?
Thanks
Matt
|
|
CIOR
Chairman
Posts: 2,046
|
Post by CIOR on Dec 4, 2009 12:52:20 GMT -5
OK, if you want to fit a GP/SD then I suggest using the Narrow version, this will fit just nice and neat into a GP/SD unit.
The wide speaker will fit nicely into F/E units, and steam.
|
|
|
|
Post by montyvox on Dec 4, 2009 15:15:32 GMT -5
Thanks Matt, I just picked it up!
|
|
CIOR
Chairman
Posts: 2,046
|
Post by CIOR on Dec 4, 2009 15:23:42 GMT -5
Should have added, make sure you get the correct Ohm speaker.
8 is typical, but there are some that don't use 8ohm.
IIRC, I think LokSound uses the higher speaker.
Its been over 2 years since I put Loksound in.
With Tsunami your good on the 8ohm.
|
|
