|
ACR GP7-9
Jul 8, 2017 16:34:03 GMT -5
via mobile
Post by bigjdme on Jul 8, 2017 16:34:03 GMT -5
Not done.lol I'm going to replace the trucks with a set of atlas trucks. And going to add a power pacK from esu.
I replaced the cracked gears installed new gears cleaned and lubed them. It runs good on the test track but at a friend's lay out it ran like crap. It's a DCC layout lots of tight industry switching and I think she keeps shorting out from the truck hitting the frame.
James
|
|
EMDX6043
Chairman
Future ex-modeler
Posts: 837
|
Post by EMDX6043 on Jul 8, 2017 21:03:31 GMT -5
Did you modify anything to create a short like that? Could just be dirty track on your friend's layout...
|
|
|
ACR GP7-9
Jul 8, 2017 23:23:12 GMT -5
via mobile
Post by bigjdme on Jul 8, 2017 23:23:12 GMT -5
His gp35 ran fine so under powered dirty track is out. I did wire both sides of the trucks to the decoder. Motor has been isolated. Not sure what I missed.
James
|
|
|
Post by bigjdme on Jul 9, 2017 8:55:35 GMT -5
His gp35 ran fine so under powered dirty track is out. I did wire both sides of the trucks to the decoder. Motor has been isolated. Not sure what I missed.
James
|
|
EMDX6043
Chairman
Future ex-modeler
Posts: 837
|
ACR GP7-9
Jul 9, 2017 12:09:23 GMT -5
via mobile
Post by EMDX6043 on Jul 9, 2017 12:09:23 GMT -5
I've had locomotives do well on the test track and run poorly on an actual layout. I'd do a really good wheel cleaning, then touch up any exposed wiring or solder with liquid electrical tape...usually deep cleaning and polishing the wheels does it for me. Sometimes there's just enough gunk where the tread meets the flange to cause problems, which would present itself in curves especially. His gp35 ran fine so under powered dirty track is out. I did wire both sides of the trucks to the decoder. Motor has been isolated. Not sure what I missed. James
|
|
|
Post by bigjdme on Jul 11, 2017 21:20:51 GMT -5
Atlas trucks sitting under the frames. Now to adapt the worm shaft to the fly wheel. James
|
|
|
ACR GP7-9
Jul 17, 2017 15:55:55 GMT -5
via mobile
Post by bigjdme on Jul 17, 2017 15:55:55 GMT -5
|
|
|
ACR GP7-9
Jul 17, 2017 16:18:27 GMT -5
via mobile
Post by bigjdme on Jul 17, 2017 16:18:27 GMT -5
|
|