matrod
Probationary Member
Posts: 19
|
Post by matrod on Feb 6, 2013 18:32:51 GMT -5
Hi Folks !
Does anybody knows what the correct eletronic plate of SoundTraxx Tsunami and speaker for OMI Models ?
For Example: Atlas,Genesys,Kato's Plate.
Tks !
Mateus Rodrigues
|
|
|
|
Post by Mark R. on Feb 6, 2013 22:53:18 GMT -5
Pretty much every Overland model is going to have to be a custom install - there's no "drop in" for brass.
Personally, I prefer using the AT-1000 board if it will fit due to it making a neater installation. I just mount the board to the top of the motor with some two-sided foam tape. If that won't fit, I'll use the shrink wrapped version and hard-wire it all together. Try to avoid the micro decoder if at all possible as they tend to have overheating issues - unless you can get them mounted flat to part of the brass structure to act as a heatsink.
Speaker ? - same rule applies to any engine .... the largest speaker you can shoe-horn in there !
Mark.
|
|
