|
Post by nsgevo on Feb 9, 2010 22:25:30 GMT -5
|
|
nssd70m2
Superintendent
Norfolk Southern Piedmont Division
Posts: 159
|
Post by nssd70m2 on Feb 10, 2010 6:55:24 GMT -5
Handrails on the front and rear. That's all I can come up with.
|
|
|
Post by peter on Feb 19, 2010 22:42:17 GMT -5
Josh, make sure you get a glossy coat of paint on this one and use microsol blue and red label setting solutions to get the decals to lay down properly BEFORE doing any clear coat. If your decal fogs up, it's not adhering and you can then use the setting solution to loosen it and take it off and consider refinishing and patch repainting the affected area to get a proper glossy surface which would accept the decal. On your other model, if the fogged decal responds to setting solutions, you might be able to remove it even at this late time and redo the affected area.
|
|
|
Post by peter on Feb 19, 2010 22:46:36 GMT -5
Josh, when I wrote "accept the decal", I meant to say , accept a new or replacement decal.
|
|
|
Post by missabemodeler on Feb 24, 2010 20:25:00 GMT -5
thanks looking nice
|
|
|
Post by nsgevo on Feb 27, 2010 17:56:21 GMT -5
Thanks! I used both the setting solutions on the other gevo, but i think the reason it did that is because I only applied the microsol once. On my recent models Ive applied it multible times and havnt been having that problem. Hm I never though of that. Maby I'll give it a shot. Thanks for the help!
|
|