Post by Stan on Oct 1, 2009 12:06:10 GMT -5
Somehow during the construction of a Cannon cab my back wall is getting warped. I constructed it pretty much as Bianna shows on his website. Took all the draft angles off and used 123 blocks to square it up all corners and it came out very nice. I didnt recheck it after glueing to the subbase. So when I got ready to put the long hood on after it was trimmed and squared according to the lines where the original cab were, I noticed the C&C cab would touch at the top and the bottom but mostly on the back wall on the side where the door is I had a nice size gap. I was able to force the wall against and apply ambroid. Its not as pretty as I would have liked but I will hold my final opinion till its primered. I should have checked the squareness of the back of the cab after I glued it to the subbase.
Any ideas?
Any ideas?
