loddie
Probationary Member
Posts: 11
|
Post by loddie on Jul 7, 2022 22:50:00 GMT -5
Hello, a number of locomotives that I would like to model have what I believe is an MU cable holder. In the linked image, you can see the round tube used to hold the disconnected end of a MU cable below the left ditch light attached to the bottom of the anti climber. Does anyone make this as an HO scale model part? SJVR 2122
|
|
|
Post by icghogger on Jul 8, 2022 9:28:12 GMT -5
I don't recall any detail parts maker doing such a part, however, it can be easily made from a section of brass or plastic tubing,
|
|
loddie
Probationary Member
Posts: 11
|
Post by loddie on Jul 8, 2022 10:38:54 GMT -5
OK, thank-you. I hadn't seen a model part, but wanted to see if there were any options before scratchbuilding. Will probably make with brass tubing and guessimate the dimensions.
|
|
|
Post by icghogger on Jul 9, 2022 10:40:18 GMT -5
About 6-inches in diameter, length to suit the application. If possible, try to use thin-wall brass tubing. Good Luck!
|
|