|
Post by lyled1117 on Jun 10, 2019 21:55:43 GMT -5
Just starting to look for the pin lifter that is used on f-unit front ends, the ones that pass below the coupler. I can't place that I've seen these done, but they haven't been on my radar until now. Looking for these in HO
Thx Lyle D
|
|
|
Post by icghogger on Jun 11, 2019 7:49:48 GMT -5
Lyle, I think what you need can be found in either the Cal-Scale 190-519 or the Detail Associates DK-701 packet.
|
|
|
Post by lyled1117 on Jun 11, 2019 8:48:37 GMT -5
Those are detail sets for f-units with all the grabs, etc, but I don't believe they come with a pin lifter. I will investigate none the less
Thx Lyle D
|
|
|
Post by icghogger on Jun 13, 2019 13:23:31 GMT -5
Not sure of the availability, but I think the Details West part #CL-316 may be what you are looking for.
|
|
|
Post by lyled1117 on Jun 13, 2019 22:17:47 GMT -5
I'll see if there is one at my LHS and check it out. What I am looking to do is create the front end lifter for a CF-7. The f-unit lifter was re-used on the CF-7 with some 'rearranging'. I found that Cal-Scale makes a plastic molded one, not sure I could reshape the bar, but perhaps it could be cut out and replaced with a wire counterpart
|
|
|
Post by icghogger on Jun 14, 2019 6:59:17 GMT -5
The DW part is metal, so you may be able to modify it to suit your needs.
|
|
fr8kar
Chairman
Little man raise the cotton, beer joints get the money
Posts: 309
|
Post by fr8kar on Jun 15, 2019 17:08:13 GMT -5
I used the Athearn Genesis F unit pin lifter on my CF7:
|
|
|
Post by lyled1117 on Jun 15, 2019 21:55:44 GMT -5
I've just ordered a Cal-Scale version of the same last night, gonna see if can get the same results as you. I may see if I can locate a Genesis version too as a backup. Any chance you have Athearn's part # for the lifter?
Lyle D
|
|
fr8kar
Chairman
Little man raise the cotton, beer joints get the money
Posts: 309
|
Post by fr8kar on Jun 17, 2019 3:05:05 GMT -5
I've just ordered a Cal-Scale version of the same last night, gonna see if can get the same results as you. I may see if I can locate a Genesis version too as a backup. Any chance you have Athearn's part # for the lifter? Lyle D Athearn HO Cut Lever Set, Genesis F ATHG19134 I got mine on ebay direct from Horizon.
|
|
|
Post by lyled1117 on Jun 21, 2019 20:35:48 GMT -5
Got the Cal-Scale version, looks pretty good. Was able to put a bend in the front one and a pair of bends for the rear one, I'm pleased with the results. Photos will be supplied soon'ish
Lyle D
|
|